Sega Daytona Championship USA Owner's Manual page 116

TABLE 16-1 ERROR MESSAGE TABLE
The game is equiped with an integral fault monitoring system. Each time an identified fault is detected an error mes-
sage is displayed on screen.
Below is a table showing possible common conditions. Please refer to them as a guide.
If the ERROR Code/Message displayed on screen id not supported by this manual then please contact your Sega
Service Centre for dignostics.
15
ERROR MESSAGE
Error - No Security Key Found
Error - Incorrect Key Inserted
Error - Security Failure
Error - I/O BD failure
Error - I/O BD disconnected
Error - Update Copy Failed
Error - Invalid Shell Update
Error - Update Copy Fail
Error - No Game Installed
Error - No Shell Installed
Game Error
108
DESCRIPTION
The system was unable to detect a
valid security key
The system found a security key
but the configuration is not valid for
this product
The system security has detected
security issues with the installed
software
The I/O Board was not detected on
power up
The IO Board was detected on
power up, but has subsequently
been disconnected from the soft-
ware
The shell was unable to create main
and backup copies of the game or
during install or update
The shell Update on the USB stick
is not a valid update
The shell was unable to create main
and backup copies of the game or
during install or update
The shell was unable to find a game
on the disk to launch. A game
needs to be installed.
Launcher was unable to find a
Shell on the disk to launch. A Shell
needs to be installed.
The game was unable to launch
or has terminated abnormally. On
reboot the game will be reinstalled
from back up. If it fails again no
further attempt to launch the game
will be made on subsequent power
cycles.
TROUBLESHOOTING
Check USB Security Key
Check USB Security Key
Restore software from recovery
USB stick
Check I/O Board, Power supply
and harnessing
Check I/O Board, Power supply
and harnessing
Check USB Install Media and re-
apply update or re-install. If still
failing restore software from USB
Recovery stick
Check USB Install Media and re-
apply update
Check USB Install Media and re-
apply update or re-install. If still
failing restore software from USB
Recovery stick
Restore software from USB
Recovery stick
Restore software from USB
Recovery stick
Restore software from USB
Recovery stick