Sega Daytona Championship USA Owner's Manual page 39

2
Fully insert the power cord connector on the side opposite the power plug into the AC unit inlet.
3
The power cord is laid out indoors. Protect the power cord by attaching wire cover to it.
If ground will be established with a ground wire made available separately, lay out the ground wire indoors
and have it protected.
After starting the initialization operation, wait until the advertising screen is
displayed or until an error screen is displayed due to the detection of an error. If
switches, etc. are inadvertently operated, faults or parts damage may occur.
1
Reinspect the assembly work, paying special attention to the points below. Finally, check that there are no
persons near the cabinet. Have all the adjusters been properly grounded, and are no casters contacting the
floor surface? Have all power cables been connected correctly? Have the covers/doors been refitted to the
cabinet? Have all fastening bolts and screws been tightened? Have any foreign objects been placed near the
seat, or have any tools or spare screws, etc. been left on or in the product? Have any foreign objects been
placed near the steering wheel?
2
Turn the main switch, located on the rear of the cockpit ON. This sends power throughout the product.
Following the order below, output locations will activate. 1) WINDOWS/SEGA logo is displayed on LCD
screen. 2) Steering Wheel calibrates - moves fully left/right then returns to the centre position. 3) Inter-
cabinet communication check (in case of communication connection setting). 4) The Game loading Screen
appears on screen. 5) Game attract sequence begins
3
If (after the initialization operation ends) the steering wheel is not at its center position (facing straight
ahead) for example, re-engage the power and conduct the initialization operation again. If the problem is
not corrected after repeating the initialization, there is most likely a fault in the volume settings. Enter Test
Mode, and check the settings. For this product, the following data and settings are still saved even if the
power is turned off. Coin numbers represented in fractions (number of coins deposited that are not enough
for one credit) and bonus adder count data are not saved.
4
Once the machine has initialised, enter the TEST screen by engaging the TEST button.
5
Carry out a routine check to make sure all INPUTS/OUTPUTS are functioning correctly. Please refer to
section 9 of this manual for information on the I/O tests and functionality.
6-6 fig. 02
6
31