Control Units - Sega Daytona Championship USA Owner's Manual

11

CONTROL UNITS

● When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit.
● Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of fire.
● Do not touch any parts that are not specified in these directions. Touching un-
specified locations may lead to electric shock or cause short circuits.
● This work should be performed by site maintenance personnel or other skilled
professionals. Work performed by non-technical personnel can cause a severe
accident such as an electric shock.
● Exercise due caution in performing soldering procedures. If soldering iron is
handled carelessly, there could be fires or burns.
● Proceed very carefully when heating thermal contraction tube. Careless
operations can result in fires or burns.
● When fastening plastic parts, be careful not to tighten screws and nuts exces-
sively or parts may be damaged, resulting in injuries from fragments, etc.
● Be careful not to get hand or finger caught when removing or attaching the parts.
● Disconnection and connection of connectors will be performed within the nar-
row cabinet space. Take due care not to scratch or otherwise injure yourself.
● Take care when carrying the removed Control Units. Such heavy lifting carries a
risk of injury to back or shoulders.
● After the Potentiometer has been replaced, be sure to set the values on the test
mode CALIBRATION and INPUT test screen, and check variations in the volume
value.
● Handle parts inside the Control Unit very carefully. Be especially careful to avoid
damage, deformation, or loss of these parts. If any one of these parts is lost or
defective, it can result in damages and/or faulty operations.
11
75