Sega Daytona Championship USA Owner's Manual page 6

• Specification changes (removal of equipment, conversion and/or addition) not designated by SEGA are
not allowed. The parts of the product include warning labels for safety, covers for personal protection, etc. It
is hazardous to operate the product by removing parts and/or modifying the circuits. Should doors, lids and
protective parts be damaged or lost, refrain from operating the product, and contact where the product was
purchased from or the office herein stated. SEGA shall not be held responsible for any accidents, compensation
for damage to a third party, resulting from the specifications not designated by SEGA.
• Ensure that the product meets the requirements of appropriate electrical specifications. Before installing
the product, check for electrical specifications. SEGA products have a nameplate on which electrical
specifications are described. Ensure that the product is compatible with the power supply voltage and frequency
requirements of the location. Using any electrical specifications different from the designated specifications can
cause a fire and an electric shock.
• Install and operate the product in places where appropriate lighting is available, allowing warning labels
to be clearly read. To ensure safety for the customers, labels and printed instructions describing potentially
hazardous situations are applied to places where accidents can be caused. Ensure that where the product is
operated has sufficient lighting allowing the warnings to be read. If any label is peeled off, apply it again
immediately. Please place an order with where the product was purchased from or the office herein stated.
• When handling the monitor, be very careful (applies only to products with monitors). Some of the monitor
parts are subject to high tension voltage. Even after turning off the power, some portions are still subject to
high tension voltage sometimes. Monitor repair and replacement should be performed only by those technical
personnel who have knowledge of electricity and technical expertise.
• Be sure to adjust the monitor properly (applies only to products with monitors). Do not operate the product
leaving on-screen flickering or blurring as it is. Using the product with the monitor not properly adjusted may
cause dizziness or a headache to an operator, a player, or the customers.
• When transporting or reselling this product, be sure to attach this manual to the product.
• In the case where commercially available monitors and printers are used in this product, only the contents
relating to this product are explained herein. Some commercially available equipment has functions and
reactions not stated in this manual. Read this manual together with the specific instruction manual of such
equipment.
• Descriptions herein contained may be subject to improvement changes without notice.
• The contents described herein are fully prepared with due care. However, should any question arise or errors be
found, please contact SEGA.
INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately after transporting
to the location. Nevertheless, an irregular situation may occur during transportation. Before turning on the power,
check the following points to ensure that the product has been transported in a satisfactory status.
• Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
• Are casters and adjusters damaged?
• Do the power supply voltage and frequency requirements meet with those of the location?
• Are all wiring connectors correctly and securely connected? Unless connected in the correct way, connector
connections can not be made accurately. Do not insert connectors forcibly.
• Do power cables have cuts and dents?
• Are all accessories available?
• Can all doors and lids be opened with the accessory keys? Can doors and lids be firmly closed?
LOCATION