Applying Power - Sega Daytona Championship USA Owner's Manual

Car 3

6-6 APPLYING POWER

Each cabinet has it own dedicated mains power input. Only use the power
leads supplied with this machine. DO NOT connect more than 2 units in any one
extension power lead. Using power leads not supplied with this product may cause
on overload situation resulting in overheating, power failure or possibly fire hazard.
• Use the power supply equipped with an earth leakage breaker. Use of
power supply without such a breaker could result in fire if there is a current
leakage.
• Do not expose the power cord or ground wire. If these are exposed,
customers could stumble over them, for instance, and easily damage
them. Additionally, if these lines are damaged, there could be a risk of
electrical shock or short circuit. Set these lines at locations where they will
not interfere with customer traffic, or attach covers to them.
• After laying out the power cord on the floor, be sure to always protect it.
If the power cord is left exposed, it can easily be damaged, resulting in
electrical shock.
• This product must only be used within the countries that it has been
designed for. If the information within this section does not appear to
match your electrical requirements then please contact the offices where
purchased before applying power.
COMMUNICATION PORTS
When connecting two or more cabinets
AC Bracket
Car 2
Network Switch
Car 1
6-5 fig. 02
Car 1 Car 2 Car 3
6-5 fig. 03
6
29