Avaya XT Telepresence Deployment Manual page 77

Before you begin
• Ensure the gatekeeper to which you registered your telepresence system is defined and
configured in Equinox Management. Refer to
page 55.
• If the endpoints you want to define as part of your telepresence system already exist in
Equinox Management as separate single endpoints, you must delete them. You then redefine
these endpoints as part of your telepresence system, as described in the procedure below.
• If your organization uses the LDAP directory and the endpoints forming the telepresence
system are defined there, we strongly recommend that you define only the primary endpoint
in your LDAP directory and remove non-primary endpoints from it.
Procedure
1. Access the Equinox Management administrator portal.
2. Click the Endpoints tab.
3. Click Add > Add manually.
The system displays the Add Endpoint window. The Add Endpoint window looks different,
depending on the model of the telepresence system you are adding. See
Endpoint window
4. Configure your telepresence endpoint, as described in
endpoints
August 2020
on page 77 .
Figure 57: Add Endpoint window
on page 78.
Avaya Video Conferencing XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
Adding Avaya XT Telepresence in Equinox Management
Configuring Basic Gatekeeper Settings
Table 14: Configuring telepresence
on
Figure 57: Add
77