Avaya XT Telepresence Deployment Manual page 24

Hide thumbs Also See for XT Telepresence:

Table of Contents

Setting up the Telepresence Room

At this stage the Avaya XT Telepresence monitors display the image transmitted by the

cameras.

9. Mark camera cables using the sticky labels.

10. Rotate the height screws on each end of the support plate to raise the angle of the left and

right cameras.

Each marking on the height measurements adds an extra 5mm to the height of the

supporting plate. For a single-row telepresence room with 50 or 55 inch monitors, set the

height to 2.5cm, or use 3cm if you have 60 or 65 inch monitors. For a dual-row

telepresence room, the cameras should remain flat (0cm).

August 2020

Figure 19: Connecting the camera cables to the XT Codec Unit

Avaya Video Conferencing XT Telepresence Deployment Guide

Comments on this document? infodev@avaya.com

Table of Contents