Avaya XT Telepresence Deployment Manual page 73

d. Select the right-hand image to calibrate the camera providing the right image.
e. Select the Pan/Tilt step by dragging the slider. The sensitivity of the slider depends
on the current zoom.
We recommend that you set the Pan/Tilt step value to 1 or 2 at the beginning of the
manual calibration to change the camera position.
f. Select the Up and Down buttons to position the camera vertically.
g. Check that this camera's vertical position is correct by using the table's surface as a
reference.
h. Place an object on the table so that its image appears on the images in the center and
on the left.
i. Verify that there are no image areas that appear on both monitors as shown in
54: Example of incorrect pan calibration
August 2020
Figure 53: Calibrating camera position manually
Avaya Video Conferencing XT Telepresence Deployment Guide
Comments on this document? infodev@avaya.com
Calibrating your Avaya XT Telepresence
on page 74.
Figure
73