Mounting Variants; Separate Lightning Protection Ring Conductor - OBO Bettermann isCon System Instructions

Mounting variants

Note!
58 | EN
7 Mounting variants
7 1

Separate lightning protection ring conductor

In the following example, the isCon
stand-off lightning protection ring conductor
the air-termination rod stand with external isCon
ened to the right height using spacers
ring conductor and connected, e.g. using Vario quick connectors.
The potential is connected to the protective equipotential bonding on the
air-termination rod via the potential connection clip
Alternatively, the potential can be connected at the air-termination rod
stand , provided that the potential connection clip
5
ing the electrical connection between the black, weakly conductive layer
or the protective jacket of the isCon
rod.
At the end of the isCon
tential connection terminal
tion ring conductor in front of the connection element
(= separation distance s multiplied by two) between the potential connec-
tion terminal
6
The conductor type isCon BA 45 SW (Basic) can be routed with or
without potential connection. If the conductor is routed without a
potential c onnection, o bserve " Mounting v ariant 2 f or i sCon B A 4 5 S W"
on page 54.
conductor
®
3
conductor and the air-termination
®
conductor, the potential is connected with a po-
®
(type isCon
6
and the rear connection element
is to be connected to a
1
. For this, we recommend
2
conductor. This is short-
®
(type isCon DH), run to the
®
(type 927 2 6-K).
4
is mounted, creat-
4
PAE) to the lightning protec-
®
. The distance x
7
should be noted.
7
OBO Bettermann