Mounting Variants; Separate Lightning Protection Ring Conductor - OBO Bettermann isCon PR 90 SW Mounting Instructions

8
8 1
Note!
2
Rd 8
7
Mounting instructions isCon

Mounting variants

Separate lightning protection ring conductor

In the following example, the isCon
a stand-off lightning protection ring conductor
mend the air-termination rod stand with external isCon
is shortened to the right height using spacers
the ring conductor and connected, e.g. using Vario quick connectors.
The potential is connected to the protective equipotential bonding on the
air-termination rod via the potential connection clip
Alternatively, the potential can be connected at the air-termination rod
stand , provided that the potential connection clip
5
ing the electrical connection between the black, weakly conductive layer
or the protective jacket of the isCon
rod.
At the end of the isCon
tential connection terminal
tion ring conductor in front of the connection element
(= separation distance s multiplied by two) between the potential connec-
tion terminal and the rear connection element
6
T he conductor type isCon BA 45 SW (Basic) can be routed with or
without potential connection. If the conductor is routed without a potential
connection, observe "Mounting variant 2 for isCon BA 45 SW" on page
53.
x
3
Fig 61: isCon ® conductor connected to stand-off ring conductor
lightning protection system
®
conductor
®
conductor and the air-termination
®
conductor, the potential is connected with a po-
®
(type isCon
6
4
1
6
5
Mounting variants
is to be connected to
1
. For this, we recom-
2
conductor. This
®
(type isCon DH), run to
®
3
(type 927 2 6-K).
4
is mounted, creat-
4
PAE) to the lightning protec-
®
. The distance x
7
should be noted.
7
57 | DE