System Accessories For Fastening; Air-Termination Rod Stand - OBO Bettermann isCon System Instructions

Product description
14 | EN
3 4

System accessories for fastening

Air-termination rod stands (see section 3.4.1) or supports for wall or pipe
mounting (see section 3.4.2) can be used to fasten the isCon
ation rods. In addition, the system offers special holders for the isCon
conductor (see section 3.4.3).
3 4 1

Air-termination rod stand

Fig 6: Air-termination rod stand with concrete blocks
The isCon
®
sizes to allow the isFang air-termination rods to be mounted on flat roofs,
for example. The tripod air-termination rod stands allow the erection of the
air-termination rods without penetrating the building structure with bolts/
anchors.
Instead, the air-termination rod stands are weighed down with FangFix
concrete blocks. The number of blocks required is dependent on the
height of the air-termination rod and the wind speed zone.
Note! Y ou can find further information on wind speed zones in the OBO TBS
lightning protection guide (order no.: 9131970) and national directives.
The air-termination rod stand can compensate for a slope in the roof sur-
face of up to 5° (see also Fig. 49 on page 45). To protect the roof sur-
face, it may be wise to place a protective film under the concrete blocks of
the air-termination rod stand. We recommend contacting the roofer about
this.
Scope of delivery of the air-termination rod stand:
– Tripod air-termination rod stand
– Crossbar for potential connection with bolt, nut and lock washer
– Brief instructions
L
Fig 7: For the dimensions of the air-termination rod stand, see Tab. 4
system contains folding air-termination rod stands of different
D
B
air-termin-
®
®
H
OBO Bettermann