Table of Contents
Advertisement
System instructions OBO isCon
Fig 34: Screwing the air-termination rod to the connection element
The internal potential connection element consists of two half shells.
These must be located in such a way that they surround the isCon
ductor and one of the half shells is located centrally beneath the screw
holes, so that it can be pressed using the side screw (see Fig. 38).
•
Place the two half shells of the potential connection element on the
conductor and push them into the retaining pipe.
Fig 35: Attaching the internal potential connection element
•
Push the retaining rod as far as it will go into the central rod. In so
doing, the opening for the left copper screw (see Fig. 38) may not
point to the gap between the half shells of the potential connection,
but centrally to one of the half shells. If necessary, turn the half shells
accordingly.
Fig 36: Pushing the retaining rod into the central rod
•
Insert the bottom part of the air-termination rod into the central mast
and fix with the side screw (20 Nm).
lightning protection
®
Assembling the air-termination rod
con-
®
EN | 37
Advertisement
Table of Contents
