Fuel - Baroness GM2810A Owner's Operating Manual

3. The appropriate oil level should be between
the upper and lower limit lines on the
gauge.
1
Inspection of Engine Oil_002
1 Oil level gauge
2 Upper limit
3 Lower limit
Supply of Engine Oil
Important
Do not supply too much engine oil. Otherwise,
the engine may be damaged.
Important
Do not mix different types of engine oil.
Important
Be sure to use engine oil that is classified as
JASO DH-2 or API Service Grade CJ-4, with
SAE viscosity that is appropriate for the
operating environment (ambient temperature).
Important
Securely tighten the oil level gauge and oil
filler cap.
1. If the engine oil level is lower than the lower
limit line on the oil level gauge, supply
engine oil through the oil filling port.
Remove the oil filler cap, and then supply
new engine oil until the oil reaches a level
in between the upper and lower limit lines
on the oil level gauge.
Inspections
2
3
rnr453-002

Fuel

Inspection of Fuel Quantity
Handling Instructions
2. Replace the oil filler cap.
Supply of Engine Oil_001
1 Oil filler cap
3. It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after supplying the oil.
With the machine on a level surface, observe
the fuel level in the monitor to check the fuel
level.
1
2
FUEL LEVEL
Inspection of Fuel Quantity_001
1 Monitor
2 Fuel level
GM2810A
1
kx9tif-006
OIL PRES
guc5f6-009
Page 4-9