Hydraulic Oil - Baroness GM2810A Owner's Operating Manual

2. Unlock the rubber catches on the left and
right of the oil cooler, and then tilt the oil
cooler.
3
2
Cleaning of Oil Cooler_001
1 Oil cooler
2 Rubber catch
3 Radiator
3. Carefully clean the front and back of the oil
cooler with water or compressed air.

Hydraulic Oil

Inspection of Hydraulic Oil
The oil gauge is on the side of the hydraulic
tank.
1. Raise the mower decks and maintain that
position on a level surface.
2. Make sure that the oil level is at the middle
of the oil gauge.
Inspection of Hydraulic Oil_001
1 Oil gauge
3. Check underneath the machine for oil
leakage.
Hydraulic Oil Supply
Important
Do not mix different types of oil.
Inspections
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
2
1. If the oil level is low, remove the left tank
cover, and then open the tank cap and
supply oil.
1
1
va4j43-005
2. Tighten the tank cap securely.
3. Start the engine, raise and lower the mower
decks, and turn the steering wheel left and
right.
Move forward and reverse repeatedly
several times.
4. Raise the mower decks and maintain that
position on a level surface, and then check
to see if the oil level is at the middle of the
oil gauge. If necessary, supply oil.
5. Check underneath the machine for oil
1
leakage.
6. Attach the left tank cover.
olekci-005
Handling Instructions
2
Hydraulic Oil Supply_001
1 Tank cap
2 Oil gauge
GM2810A
dmhzyz-013
Page 4-5