Throttle Knob; Diff-Lock Switch; Traveling Pedal - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
1
A
B
C

Throttle Knob

The throttle knob is located to the right of the
driver's seat and enables you to adjust the
engine rpm.
Move the throttle knob toward the "High speed"
position to increase the engine rpm, and
toward the "Low speed" to reduce the rpm.
Note:
The factory default engine rpm (maximum) is
set to 2,600 rpm.
Throttle Knob_001
1
A
B

Diff-Lock Switch

Important
Do not operate the diff-lock switch unless it is
necessary.
The diff-lock switch is located below the right
side of the steering wheel and engages the
differential lock for the left and right front
wheels.
Tilt the switch lever up or down to turn "ON" to
engage the differential lock for the front
wheels.
Release the switch lever to return it to the
neutral position ("OFF" position) and disengage
the differential lock.
Page 4-32
Mower deck up/down lever
Raise
Neutral
Lower
B A
Throttle knob
High speed
Low speed

Traveling Pedal

Caution
When the machine is traveling at a high
speed, it will not stop immediately after you
1
take your foot off the traveling pedal.
If necessary, also use the brake.
The traveling pedals are located in the right
foot area and control forward and reverse
5kfhjl-007
operation of the machine.
When the forward pedal (inside) is depressed,
the machine travels forward. When the reverse
pedal (outside) is depressed, the machine
travels in reverse.
The speed changes in accordance with how
much the pedal is depressed.
When you take your foot off the pedal, the
machine stops automatically.
A
B
A
1
Diff-Lock Switch_001
1 Diff-lock switch
A ON (Lock)
B OFF (Release)
1
Traveling Pedal_001
1 Forward pedal
2 Reverse pedal
Operation Method
k3y8px-002
2
yo3h9x-002