GM2810A
Handling Instructions
Tire
Inspection of Tires
1.
Check the pneumatic pressure of the tires.
2.
Make sure that there are no cracks,
damage or abnormal wear.
Tire size
Front wheel (29 x 14.00 -
15)
Rear wheel (20 x 12.00 -
10)
Brake
Inspection of Brake
While traveling, depress the brake pedal
firmly to make sure that the brake is applied
effectively.
Inspection of Parking Brake
1.
Make sure that the parking brake is applied
after depressing the brake pedal and
pulling the parking brake lever.
2.
Make sure that the parking brake is not
applied even slightly after depressing the
brake pedal to release the parking brake
lever.
Belt
Inspection of Belt
Warning
The engine must be stopped when the belt is
inspected.
Important
A slacking or damaged belt or damaged fan
may cause overheating or lack of a battery
charge.
1.
Press the middle of the belt with your finger
to check the belt tension.
2.
Make sure that there are no cracks,
damage or abnormal wear.
Wire
Inspection of Wire
1.
Make sure that the wire is not cracked or
damaged.
Page 4-8
Pneumatic pressure
2
150 kPa (1.5 kgf/cm
)
2
140 kPa (1.4 kgf/cm
)
2.
If the wire is cracked or damaged, replace it
with a new one immediately.
Around The Engine
Inspection of Engine-Associated Parts
Caution
Implement after the engine and DPF etc. have
well cooled down.
Otherwise you may get burned.
1.
Check the fuel system parts for loosened or
cracked joints and leakage. Replace the
parts if necessary.
2.
Blow compressed air to clean any grass or
flammable materials that may be attached
on or around the DPF.
Remove clippings and dust in a gap
thoroughly due to the intricately shaped
engine.
Engine Oil
Inspection of Engine Oil
Important
Securely tighten the oil level gauge and oil
filler cap.
1.
Stop the engine, wait for 10 to 20 minutes
for the engine to cool down, and then check
the oil level.
2.
Position the machine so that the engine will
be level, and then insert the oil level gauge
all the way to check the oil level.
1
Inspection of Engine Oil_001
1
bgmiun-013
Oil gauge
Inspections