Adjustment Of Belt Tension - Baroness GM2810A Owner's Operating Manual

GM2810A
Maintenance
Rear Tire
Follow the steps below to remove the rear
tire.
1. Loosen the bolts.
1
1
2
2. Securely place the jack beneath the jack-up
point below the rear wheel motor, and then
raise it until the tire lifts off the ground.
"Jack-Up Points" (Page 5-19)
3. Remove the bolts.
4. Remove the tire from the wheel mounting
base.
Important
Tighten the bolts in the tightening order
(diagonally).
For installing the rear tire, reverse the
removing procedure.

Adjustment of Belt Tension

Warning
Be sure to stop the engine before adjusting
the belts.
Important
Before making sure of belt tension, rotate the
belt several times.
If the belt becomes slack due to frequent use, it
may jump or slip.
In addition, if it is overtightened, it may wear
prematurely.
If necessary, adjust it, and always check the
belt for appropriate tension.
Page 5-30
2
Rear Tire_001
Rear tire
Heat-treated bolt
Fan Belt
1. Press the middle of the belt with your finger
to check the belt tension.
2. If the belt tension is inappropriate, loosen
bolts A and B (that affix the alternator), and
then move the alternator to adjust the
tension.
jnpvbf-001
2
A
1
Fan Belt_001
1 Fan belt
2 Blade
3 Alternator
4 Bolt A
5 Bolt B
A 7.0 - 9.0 mm (0.28 - 0.35 in)
Maintenance Work
5
3
4
mzdn8n-003