Cutting Work - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
7. Pull up the lever behind the seat to unlock it,
and then tilt the seat forward to open the
cover.
2
A
1
Towing The Machine_004
1
2
A
B
8. Turn the unload valve, located beside the
hydraulic pump, 90 degrees (so that it is
vertical) to open it.
Towing The Machine_005
1
9. Replace the seat and close the cover.
10. Remove the wheel stopper.
11. Depress the brake pedal to release the
parking brake.
Warning
While towing, always keep your foot on the
brake pedal and depress the brake pedal at
any time to stop.
12. Tow the machine slowly.
Page 4-72
B
Lever
Seat
Pull up
Tilt forward
1
gay3t1-005
Unload valve

Cutting Work

Cutting Operation
Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Caution
ljffir-003
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Please note that if you stop operating the
mower deck up/down lever before the mower
decks are raised completely, knife rotation
may not stop.
Knife rotation will be turned on or off based on
the sensor-detected position of the mower
decks.
Caution
Be sure that people around the machine keep
a safe distance away.
1. Start the engine.
"Procedure to Start Engine" (Page 4-21)
2. Raise all mower decks.
3. Depress the brake pedal to release the
parking brake.
4. Shift the throttle lever to the "High speed"
position to run the engine at the maximum
rpm.
5. Right before starting cutting work, release
the mower lock levers for mower decks #4
and #5.
6. Shift the mower deck up/down lever to the
"Lower" position to lower the mower decks.
7. Set the knife rotation switch to the "Rotation"
position to rotate the rotary knives of all
mower decks.
8. Depress the traveling pedal to start cutting
work.
Cutting Work