Fuel - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
Supply of Engine Oil
Important
Do not supply too much engine oil. Otherwise,
the engine may be damaged.
Important
Do not mix different types of engine oil.
Important
Be sure to use engine oil that is classified as
JASO DH-2 or API Service Grade CJ-4, with
SAE viscosity that is appropriate for the
operating environment (ambient temperature).
Important
Securely tighten the oil level gauge and oil
filler cap.
1. If the engine oil level is lower than the lower
limit line on the oil level gauge, supply
engine oil through the oil filling port.
Remove the oil filler cap, and then supply
new engine oil until the oil reaches a level
in between the upper and lower limit lines
on the oil level gauge.
2. Replace the oil filler cap.
Supply of Engine Oil_001
1
3. It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after supplying the oil.
Page 5-12
Oil filler cap

Fuel

Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel level in the monitor to check the fuel
level.
1
2
Fuel Supply
Warning
Do not supply additional fuel after the fuel
level indicates 100%.
If you supply too much fuel, it might overflow
from the fuel cap when you travel or work on a
slope.
Warning
Keep fire away while refueling.
Do not smoke.
1
Important
Use ultra-low sulfur diesel fuel (sulfur-free
diesel fuel).
kx9tif-006
Important
In case of lack of fuel, DPF regeneration can
not be performed.
If the monitor displays the warning message
"FUEL LEVEL LOW", immediately stop
operation, and then supply fuel (diesel).
The fuel tank capacity is approximately 51.0
3
dm (51.0 L).
FUEL LEVEL OIL PRES
Inspection of Fuel Quantity_001
1 Monitor
2 Fuel level
Inspection and Cleaning
guc5f6-009