Change Of Hydraulic Oil Filter - Baroness GM2810A Owner's Operating Manual

GM2810A
Maintenance

Change of Hydraulic Oil Filter

Change of Hydraulic Oil Line Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When replacing the hydraulic oil filter, be sure
to drain the oil into a container and discard it
in accordance with local laws and regulations.
Important
If the hydraulic oil emulsifies or if it becomes
even slightly less transparent, change the oil
immediately.
Important
Use Shell Tellus S2M46 (or equivalent) as
hydraulic oil.
1. On a level surface, lower the mower decks,
and then stop the engine.
2. Remove the filter protection plate.(#11021-)
1
Change of Hydraulic Oil Line Filter_001
1
2
3
3. Loosen the old filter cartridge by hand and
remove it.
4. Lightly coat the packing of the new filter
cartridge with hydraulic oil, and then install
the cartridge.
Page 5-36
3
2
ycfdh6-024
Filter cartridge
Filter protection plate
Bolt
5. Firmly tighten the filter cartridge by hand
until the packing contacts the mounting
surface.
And then tighten it with a half more turn.
1
Change of Hydraulic Oil Line Filter_002
1 Filter cartridge
6. Supply hydraulic oil until it reaches the
specified level.
"Hydraulic Oil Supply" (Page 4-5)
7. Start the engine and stop it after hydraulic
oil warmed.
8. Check underneath the machine for
hydraulic oil leakage.
9. Install the filter protection plate.(#11021-)
ycfdh6-015
Maintenance Work