Safety Mechanisms; Warning Mechanisms - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
Procedure to Stop Engine
1. Set the traveling pedal to the neutral
position.
2. Apply the parking brake.
3. Set the knife rotation switch to the "Stop"
position.
4. Shift the throttle knob to the "Low speed"
position, and then idle the machine for 1-2
minutes.
5. Switch the ignition key to the "OFF"
position.
6. Make sure that the engine has stopped.
7. Remove the ignition key.
8. Leave the driver's seat.

Safety Mechanisms

This machine features a safety device for
starting/stopping the engine.
1. As for starting the engine, the safety device
prevents the engine from starting unless it
meets each of the following four conditions.
･ An operator is sitting on the seat.
The parking brake is applied.
･
The knife rotation switch is set to the
･
"Stop" position.
The traveling pedal is set to the neutral
･
position.
Important
When you restart the engine after the safety
device stops the engine, be sure to return the
ignition key to the "OFF" position first, and
then restart it.
Otherwise the engine does not start.
2. In the event the operator leaves the seat with
the parking brake applied and the engine
running, the safety device will be activated
and will stop the engine under any of the
following conditions:
The traveling pedal is not set to the neutral
･
position. (The operator has depressed the
traveling pedal.)
The knife rotation switch is set to the
･
"Rotation" position.
Page 4-22

Warning Mechanisms

Important
When the buzzer (intermittent tone) sounds,
be sure to stop operation since the engine is
overheated.
Do not stop the engine without idling. Allow
the engine to cool down, first. Keep the engine
idling for about 5 minutes before stopping.
Remove dust that is jamming in the radiator,
air cleaner, and etc.
This machine features warning mechanisms for
overheating, the hydraulic oil and the engine.
1. If the engine water temperature exceeds 115
degrees Celsius, a buzzer will sound.
(intermittent tone)
2. If the oil level in the hydraulic tank declines
from the specified level by approximately 2.0
3
dm (2.0 L), a buzzer will sound. (continuous
tone)
3. With an engine malfunction, a monitor LED
lights up and a fault code appears.
Procedure to Start/Stop Engine