Fuel - Baroness LM180E Owner's Operating Manual

3. The appropriate engine oil level should be
between the upper and lower limit lines on
the gauge.
2
3
Inspection of Engine Oil_002
1 Oil level gauge
2 Upper limit
3 Lower limit
Supply of Engine Oil
Important
Do not supply too much engine oil. Otherwise,
the engine may be damaged.
Important
Do not mix different types of engine oil.
Important
Be sure to use engine oil that is classified as
API Service Grade SE or higher, with an SAE
viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Securely tighten the oil level gauge.
1. Remove the oil level gauge.
2. Supply new engine oil from the oil filling
port until it reaches the upper limit line on
the oil level gauge.
3. Position the machine so that the engine is
level, and then check the engine oil level
without tightening the oil level gauge in the
oil filling port.
Inspections
1
bgmiun-015
Handling Instructions
4. Securely tighten the oil level gauge.
2
Supply of Engine Oil_001
1 Oil level gauge (oil filling port)
2 Drain plug
5. It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after replenishment.

Fuel

Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel gauge on the fuel tank to check the
fuel level.
Inspection of Fuel Quantity_001
1 Fuel gauge
LM180E
1
bgmiun-031
1
guc5f6-007
Page 4-5