Oil Cooler - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
Coolant Supply
Caution
Do not touch the radiator or coolant during
engine operation or right after the engine has
been turned off.
Due to high temperatures, doing so could
cause burns.
Caution
Supply coolant after the engine has well
cooled down.
Caution
The radiator cap is pressurized.
If you remove the radiator cap while the
engine is overheated, hot steam will burst out,
possibly resulting in burns.
Make sure that the water temperature and
pressure are reduced, and then grab the cap
with a thick cloth and gradually open the cap.
Important
When you supply coolant, be sure to use
clean water, such as tap water.
Important
Tightly close the radiator cap.
If the cap is loose or incorrectly installed,
water may leak and the engine may overheat.
1. If the coolant level in the reserve tank is
lower than the "LOW" mark, open the
reserve tank cap and fill the tank with clean
water up to the "FULL" mark.
Coolant Supply_001
1
Page 4-4
ouuoov-013
Reserve tank
2. If no coolant is in the reserve tank, follow
the steps below to fill the tank with clean
water.
[1] Open the radiator cap, and then supply
clean water up to the opening.
[2] Open the reserve tank cap, and then
supply clean water up to the "FULL"
mark.
1

Oil Cooler

Inspection of Oil Cooler
1. Make sure that there is no damage to the
oil cooler.
2. Make sure that the oil cooler is not
contaminated.
Cleaning of Oil Cooler
Important
An unclean oil cooler may cause malfunction
of the hydraulic system.
Important
Do not use solid objects, such as a spatula or
screwdriver, or high-pressure water to clean
the radiator or oil cooler.
Otherwise, special fins or tubes may be
damaged, possibly resulting in reduced
cooling performance or coolant leakage.
If the oil cooler has been contaminated with
dust, be sure to clean it.
After operating the machine in a dusty
1
environment, it is important to remove dust as
soon as possible.
1. Open the radiator cover.
Coolant Supply_002
1 Radiator cap
ouuoov-014
Inspections