Water Separator - Baroness GM2810A Owner's Operating Manual

GM2810A
Handling Instructions
Fuel Supply
Warning
Do not supply additional fuel after the fuel
level indicates 100%.
If you supply too much fuel, it might overflow
from the fuel cap when you travel or work on a
slope.
Warning
Keep fire away while refueling.
Do not smoke.
Important
Use ultra-low sulfur diesel fuel (sulfur-free
diesel fuel).
Important
In case of lack of fuel, DPF regeneration can
not be performed.
If the monitor displays the warning message
"FUEL LEVEL LOW", immediately stop
operation, and then supply fuel (diesel).
The fuel tank capacity is approximately 51.0
3
dm (51.0 L).
Note:
The factory default low fuel level is 10%.The
level can be changed optionally.
1
2
FUEL LEVEL
Fuel Supply_001
1
2
Air Bleeding of Fuel System
1. Open the hood.
2. Set the key switch to the "ON" position and
then start the electromagnetic pump.
Page 4-10
OIL PRES
guc5f6-009
Monitor
Fuel level
3. A priming pump is installed on the feed
pump.
Repeatedly press the top of the priming
pump with your finger until resistance is felt,
to bleed air.
4. Set the key switch to the "OFF" position.
5. Close the hood.
1
Air Bleeding of Fuel System_001
1
2

Water Separator

Inspection of Water Separator
Important
If water contaminates the fuel, the supply
pump and injector may seize.
The water separator removes water from the
fuel.
1. Make sure that debris and water have not
accumulated in the cup.
With the float raised, water incorporation is
confirmed.
5
4
2
1
Inspection of Water Separator_001
kou8ls-005
Feed pump
Priming pump
3
v1spa6-001
Inspections
2