Procedure To Start/Stop Engine; Start/Stop Of Engine - Baroness GM2810A Owner's Operating Manual

Procedure to Start/Stop Engine

Start/Stop of Engine

Procedure to Start Engine
Caution
Before starting the engine, make sure that
there are no other people or obstacles around
the machine.
Important
When restarting the engine after it has been
turned off, wait until the electromagnetic pump
has fully stopped before restarting the engine.
The electromagnetic pump will stop
approximately 7 seconds after the key switch
is turned to the "OFF" position.
Important
Starter operation must take 15 seconds or
less.
If the engine does not start, stop using the
battery for 30 to 60 seconds to avoid
exhausting the battery.
1. Sit on the seat.
2. Make sure that the parking brake is applied.
3. Make sure that the knife rotation switch is in
the "Stop" position.
4. Make sure that the traveling pedal is in the
neutral position.
5. Move the throttle knob halfway from the
"Low speed" position toward the "High
speed" position.
6. Switch the ignition key to the "ON (GLOW)"
position.
Procedure to Start Engine_001

Procedure to Start/Stop Engine

1
2
3
v2e27i-071
Handling Instructions
1 OFF
2 ON (GLOW)
3 START
Important
When the ignition key is switched to the "ON"
position, "Warming up" may appear in the
monitor display.
Do not start the engine until the message
disappears.
7. Make sure that the glow plug is generating
heat, the "BARONESS" logo or "Warming
up" message appears in the monitor
display, and the yellow and red LEDs are lit.
2
1
Quality on Demand
Procedure to Start Engine_002
1 Monitor display
2 Yellow LED
3 Red LED
Important
Quickly returning the ignition key from the
"START" position to the "ON" position may
result in damage to the machine.
8. After the "BARONESS" logo and the yellow
and red LEDs go off and the parameters
(items and values such as the rotation
speed) appear, immediately set the ignition
key to the "START" position.
9. When the starter starts rotating and the
engine starts, slowly return the ignition key
to the "ON" position.
10. Move the throttle knob to the "Low speed"
position, and then warm up the engine for
1-2 minutes.
11. Gradually move the throttle knob toward the
"High speed" position.
GM2810A
3
v2e27i-027
Page 4-21