Traction Assist Switch; Mower Lock Lever (Latch); Mower Deck Up/Down Lever - Baroness GM2810A Owner's Operating Manual

Traction Assist Switch

The traction assist switch is located in the
operation panel.
This switch is effective to increase climbing
ability when this machine is in cutting operation
(4WD).
The cylinders are pressurized even with the
･
switch set to the "OFF" position and so the
mower decks are a little raised.
･ When the switch is set to the "ON" position,
the traction assist mode is automatically
switched and the power lifting the mower
decks and climbing ability are increased.
When the switch is set to the "ON" position
･
and the machine is in cutting operation on a
slope of 13 degrees or more, the power
lifting the mower decks and climbing ability
are further increased.
Note:
Tracking may be impaired if the machine is
used with the switch set to the "ON" position in
an area with many undulations.
Traction Assist Switch_001
1 Traction assist switch
A ON
B OFF

Mower Lock Lever (Latch)

The mower lock levers (latches) are located in
the foot area on the left and right sides.
Hook the mower lock levers (latches) on the
arms to keep the mower decks #4 and #5
raised.
The mower lock levers (latches) may be used
for the following operations.
Moving by the machine
･
Transporting the machine
･
･ Storing the machine
Operation Method
1
A
B
b9ycf8-003
Handling Instructions
Mower Lock Lever (Latch)_001
1 Mower lock lever (latch)

Mower Deck Up/Down Lever

Caution
Before raising or lowering the mower decks,
make sure that there are no people around
the machine.
Important
When the mower lock levers (latches) are
engaged, do not operate the mower deck up/
down lever.
The mower deck up/down lever is located in
the operation panel and raises or lowers the
mower decks.
When the lever is shifted to the "Lower"
position, the mower decks are lowered. When
the lever is shifted to the "Raise" position, the
mower decks are raised.
Release the lever to return it to the neutral
position.
Note:
When the mower decks are raised, the rotary
knives stop rotating, even if the knife rotation
switch is set to the "Rotation" position.
Mower Deck Up/Down Lever_001
GM2810A
1
xqolpb-001
B
A C
1
lwkjk9-001
Page 4-31