Conditions For Dpf Regeneration; Pm Accumulation Level - Baroness GM2810A Owner's Operating Manual

5. Stop the engine.
6. Contact your dealer for DPF replacement.

Conditions for DPF Regeneration

Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Important
If DPF regeneration is interrupted before it is
completed, the next regeneration may be
requested soon since not all of the PM (soot)
was removed.
Important
Perform DPF regeneration when the engine
sufficiently warmed up.
1. DPF auto regeneration does not begin
unless both of the following two conditions
are met.
･ The DPF auto regeneration inhibit switch
is set to the "Auto regeneration mode".
(Auto regeneration inhibit icon is turned
off.)
The coolant temperature is 50 °C or more.
･
2. DPF parked regeneration and manual
regeneration do not begin unless all of the
following four conditions are met.
The parking brake is applied.
･
The traveling pedal is in the neutral
･
position.
The throttle opening is 0% (idling).
･
The coolant temperature is 50 °C or more.
･
3. During DPF regeneration, the operation is
canceled if any of the following conditions
occur.
･ Any condition for starting regeneration is
violated.
･ The ignition key is switched to the "OFF"
position.
DPF

PM Accumulation Level

Level 0
DPF regeneration is not necessary.
Level 1
Danger Danger
Since it will become extremely hot around the
exhaust outlet during DPF regeneration, do
not perform the regeneration in a location
where fires may occur.
Caution
Normally, set the DPF auto regeneration
inhibit switch to the "Auto regeneration mode".
However, when operating in a location where
fires may occur, set the DPF auto
regeneration inhibit switch to the "Auto
regeneration inhibit mode".
Important
When the system enters the level where DPF
regeneration is required, perform the
regeneration immediately.
Interrupting the regeneration or ignoring the
warning and continuing traveling or cutting
work may cause the engine and DPF to
malfunction.
Important
If the regeneration remains uncompleted even
after 30 minutes have passed since the start
of automatic regeneration in PM accumulation
"Level 1", PM accumulation level enters
"Level 2".
You can continue to use this machine for
･
traveling and cutting work during DPF
regeneration.
You cannot continue to use this machine
･
for traveling and cutting work during DPF
parked regeneration.
･ You can operate this machine to perform
the regeneration. (The fault diagnostic tool
is not required.)
GM2810A
Maintenance
Page 5-13