Adjusting The Neutral Position Of The Piston Pump - Baroness GM2810A Owner's Operating Manual

GM2810A
Maintenance
7. With the brake pedal released, obtain a play
of 1.0 mm (0.039 in) at the connection of the
inner wire.
2
Adjustment of Brake_004
1
2
3
4
A
8. Use a wrench to loosen the lock nut and
tighten it after making the adjustment with
the adjustment bolt.
9. Drive, and then check the following.
Make sure that heat is not generated in
･
the brake area.
Make sure that the left and right brakes
･
are equally effective.
Caution
It may result in an unexpected accident if the
left and right brakes are not equally effective.
10. If the left and right brakes are not equally
effective, make fine adjustments with the
adjustment bolt on the brake wire.
Adjustment of Brake_005
1
Page 5-32
A
4
3 1
Inner wire
Adjustment bolt
Lock nut
Connection
1.0 mm (0.039 in)
Adjustment bolt (on brake disc side)
Break-In of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
Adjusting the Neutral Position of the Piston
Pump
Caution
nfzln9-026
Make sure not to touch rotating tires.
Caution
When adjusting the neutral position, pay close
attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
1. Stop the engine.
2. Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
3. Make sure that no tires come into contact
with the jack stand.
4. Make sure that the steering wheel is raised
completely.
5. Pull up the forward/backward adjustment
lever, and then slide the seat backward
completely.
1
1
nfzln9-012

Adjusting the Neutral Position of the Piston Pump_001

2
1 Forward/backward adjustment lever
2 Seat
Maintenance Work
v1bfn5-001