Adjustment Of Brake - Baroness GM2810A Owner's Operating Manual

Adjustment of Brake

Caution
Make sure that the brake wire is not cracked
or damaged.
Important
If the brake is not sufficiently effective due to a
larger clearance between the brake disc and
the pad, adjust the clearance.
The wire is used for fine adjustments.
Important
Adjust the brake with the brake pads.
The brake pad wear limit is 3.0 mm (0.12 in).
Adjustment of Brake_001
1 Brake disc
2 Brake pad
Important
Make sure that the lever is maintained in the
open position (neutral).
1. For each wheel, fully tighten the adjustment
bolt on the brake disc side.
2
Adjustment of Brake_002
Maintenance Work
2
1
nfzln9-009
A
1
nfzln9-010
1 Adjustment bolt (on brake disc side)
2 Lever
A Open (neutral)
2. Reduce the clearance by loosening the lock
nut, then tightening the adjustment nut.
Tighten the adjustment nut until the friction
material contacts the friction surface of the
disc.
1
Adjustment of Brake_003
1 Brake disc
2 Wire
3 Adjustment nut
4 Lock nut
Warning
A clearance between the brake disc and the
pad that is too small may result in heat
generation or fire.
3. Loosen the adjustment nut to adjust the
clearance between the brake disc and the
pad to about 0.2 mm (0.0079 in).
4. Securely place the jack beneath the jack-up
point of the front left/right frame area, and
then raise it until both tires lift off the ground.
5. Check that the disc rotates freely.
6. Tighten the lock nut, and then fully tighten it
while holding the adjustment nut in place.
GM2810A
Maintenance
2
3
4
nfzln9-011
Page 5-31