Cutting Work; Transporting; Storage; Cutting Operation - Baroness LM180E Owner's Operating Manual

1 Frame
5. Raise all mower units.
6. Set the change lever to the "Neutral"
position.
7. Remove the wheel stoppers.
8. Release the parking brake.
Warning
While towing, always keep your foot on the
brake pedal and depress the brake pedal at
any time to stop.
9. Tow the machine slowly.

Cutting Work

Cutting Operation

Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
1. Lower all the mower units.
2. Start the engine.
"Procedure to Start Engine" (Page 4-13)
3. Move the throttle lever to the "High speed"
position.
4. Shift the change lever in arbitrary position.
5. Slowly pull the reel rotation lever in the same
way as clutch-slipping to rotate the reel
cutters (cutting cylinders) of the left and right
mower units.
6. Slowly pull the traveling clutch lever in the
same way as clutch-slipping to move the
machine forward while rotating the reel cutter
(cutting cylinder) of the rear mower unit.
7. Shift the traveling clutch lever to the "ON"
position, and then start the operation.

Transporting

Transporting Procedure

When loading the machine into a trailer or a
truck to transport it, drive the machine in
reverse. When unloading, drive the machine
forward.

Cutting Work

Handling Instructions

Storage

Before Long-Term Storage

1. Cleaning
Remove dirt, grass clippings, oil stains etc.
･
completely from the main vehicle and
engine.
2. Replacing oil
Inspect and replace the engine oil and
･
element.
3. Greasing and lubricating
･ Supply oil and apply grease to appropriate
parts.
4. Fuel
Remove the fuel from the fuel tank.
･
5. Tire pneumatic pressure
Set the tire air pressure slightly higher
･
than normal, and then place the machine
on a board to avoid humidity.
6. Mower units
When storing this machine, lower all the
･
mower units unless a positive mechanical
lock is provided.
7. Storage location
Cover the machine and store it in a dry
･
place where it will not be exposed to rain.
LM180E
Page 4-21