Move; Cutting Work; Traveling Procedure; Cutting Operation - Baroness GM2810A Owner's Operating Manual

Move

Traveling Procedure

Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Caution
When traveling, be sure to stop the rotary
knives and raise the mower decks.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
1. Start the engine.
"Procedure to Start Engine" (Page 5-19)
2. Make sure that all the mower decks are
raised and that the mower lock levers
(latches) for mower decks #4 and #5 are
hooked.
3. Depress the brake pedal to release the
parking brake.
4. Release the brake pedal.
5. Slowly depress the traveling pedal.
6. The machine starts traveling.
7. The machine stops slowly when the traveling
pedal released.

Cutting Work

Cutting Operation

Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.

Move

Handling Instructions
Caution
Please note that if you stop operating the
mower deck up/down lever before the mower
decks are raised completely, knife rotation
may not stop.
Knife rotation will be turned on or off based on
the sensor-detected position of the mower
decks.
Caution
Be sure that people around the machine keep
a safe distance away.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
1. Release the mower lock levers for mower
decks #4 and #5 just before cutting
operation.
2. Start the engine.
"Procedure to Start Engine" (Page 5-19)
3. Depress the brake pedal to release the
parking brake.
4. Shift the throttle knob to rev the engine up to
the maximum rpm.
5. Shift the mower deck up/down lever to the
"Lower" position to lower the mower decks.
6. Set the knife rotation switch to the "Rotation"
position to rotate the rotary knives of all
mower decks.
7. Depress the traveling pedal to start cutting
work.
Note:
During the work, the rotary knives will rotate or
stop in sync with the up and down motion of
the mower decks.
GM2810A
Page 5-21