Installing The Cooling Fan Assembly - Dell EMC PowerEdge R940xa Installation And Service Manual

Figure 33. Removing the cooling fan assembly
Next steps
1. Replace the cooling fan

Installing the cooling fan assembly

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
CAUTION: Observe the routing of the cable as you remove it from the system. Route the cable properly when you
replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guide slots on the cooling fan assembly with the standoffs on the system.
2. Lower the cooling fan assembly into the system until the cooling fan connectors engage with the connectors on the system board.
3. Press the release levers to lock the cooling fan assembly in place.
58 Installing and removing system components
assembly.
Safety instructions.
Before working inside your system.