How To Save Measurement Results - Agilent Technologies ESA-E Series User And Programming Manual

Setting Up the Modulation Analysis Mode
Preparing to Make Measurements

How to Save Measurement Results

To save measurement results follow the process shown below. For additional
information on file management in the spectrum analyzer, refer to the ESA
Spectrum Analyzers User's Guide.
1. Press File , Save , Type
2. If you want to change the file name, press
enter the new name. For more information on using the Alpha Editor, refer to
the ESA Spectrum Analyzers User's Guide.
3. The default directory is the C: drive. If you want to change the file directory,
press (or
Dir Up Dir Select)
directory and then press
4. Press to complete the file saving process.
Save Now
5. If you have used the default file name and wish to save additional measurement
results, press . The current measurement result will be saved with the next
Save
default file name.
6. If you have not used the default file name and wish to save additional
measurement results, repeat steps 1 through 3.
20
, More , Measurement Results
Name
and use the up or down arrows to select the desired
Dir Select .
.
, and use the Alpha Editor the
Chapter 3