Radio Standards Commands - Agilent Technologies ESA-E Series User And Programming Manual

Programming Language Reference
SENSe Subsystem
INTernal - uses 10 MHz internal time base
EXTernal - uses the signal at the rear panel external reference input
port.
Preset
and *RST: INTernal
Front Panel
Access:
Mode Setup, Demod...
or
Det/Demod, More

Radio Standards Commands

Radio Standard Alpha / BT ratio
[:SENSe]:RADio:STANdard:ALPHA <alpha / BT number>
[:SENSe]:RADio:STANdard:ALPHA?
Enter the required Alpha / BT filter characteristics of a Nyquist, Root
Nyquist, or Gaussian filter.
Alpha/BT is only applicable if either the reference or measure filters are
set to: Gaussian, Nyquist or Root Nyquist. All other cases will be greyed
out.
Factory Preset
and *RST: 0.22
Maximum Value: 1.0
Minimum Value: 0
Front Panel
Access:
Mode Setup, Demod...
or
Det/Demod
Radio Device Under Test
[:SENSe]:RADio:STANdard:DEVice[:SELect] BTS|MS
[:SENSe]:RADio:STANdard:DEVice[:SELect]?
Select the type of radio device to be tested.
BTS – Base transceiver station test.
MS – Mobile transceiver station test.
136 Chapter 7