Configure Subsystem; Configure The Selected Measurement - Agilent Technologies ESA-E Series User And Programming Manual

Programming Language Reference

CONFigure Subsystem

CONFigure Subsystem
The CONFigure commands are used with several other commands to
control the measurement process. These commands are described in the
section on the "MEASure Group of Commands" on page
Each measurement sets the instrument state that is appropriate for
that measurement. Other commands are available for each
allow changing settings, view, limits, etc. Refer to:
SENSe:CHANnel, SENSe:EVM, SENSe:FREQuency,
SENSe:MONitor, SENSe:OPTion, SENSe:RADio, SENSe:SYNC
DISPlay:<measurement>,
TRIGger

Configure the Selected Measurement

:CONFigure:<measurement>
A CONFigure command must specify the desired measurement. It will
set the instrument settings for that measurement's standard defaults,
but will not initiate the taking of data. The available measurements are
described in the MEASure subsystem.
100
113.
to
Mode
Chapter 7