Agilent Technologies ESA-E Series User And Programming Manual page 136

Programming Language Reference
SENSe Subsystem
Factory Preset
and *RST: Off and disabled
Remarks: You must be making an EVM measurement on an
externally triggered EDGE signal to use this command.
Front Panel
Access:
Frequency Channel
Training Sequence Code (TSC)
[:SENSe]:CHANnel:TSCode <integer>
[:SENSe]:CHANnel:TSCode?
Set the normal training burst sequence code for which to search when
TSC auto is set to Off.
Factory Preset
and *RST: 0
Range: 0 to 7
Remarks: You must be making an EVM measurement on an
EDGE (8PSK) signal to use this command.
Front Panel
Access:
FREQUENCY Channel
Training Sequence Code (TSC) Auto
[:SENSe]:CHANnel:TSCode:AUTO OFF|ON|0|1
[:SENSe]:CHANnel:TSCode:AUTO?
Select auto or manual control for training sequence code (TSC) search.
With auto on, the measurement is made on the first burst found to have
one of the valid TSCs in the range 0 to 7 (i.e. normal bursts only). With
auto off, the measurement is made on the 1st burst found to have the
selected TSC.
Factory Preset
and *RST: On
Remarks: You must be making an EVM measurement on an
EDGE (8PSK) signal to use this command.
Front Panel
Access:
FREQUENCY Channel
122 Chapter 7