Frequency Commands - Agilent Technologies ESA-E Series User And Programming Manual

Programming Language Reference
SENSe Subsystem
Error Vector Magnitude—Measurement Interval
[:SENSe]:EVM:SWEep:POINts <integer>
[:SENSe]:EVM:SWEep:POINts?
Sets the number of symbols per measurement sweep or measurement
interval.
Factory Preset
and *RST: 200
Range: 10 to 350
Front Panel
Access:
Meas Setup
Error Vector Magnitude—Trigger Source
[:SENSe]:EVM:TRIGger:SOURce IMMediate|EXTernal|RFBurst
[:SENSe]:EVM:TRIGger:SOURce?
Select the trigger source used to control the data acquisitions.
IMMediate – the analyzer will process input data immediately
without waiting for any sort of trigger signal. This is sometimes
called 'Free Run'.
EXTernal – rear panel external trigger input
RFBurst – wideband RF burst envelope trigger that has automatic
level control for periodic burst signals
Factory Preset
and *RST: Immediate
Front Panel
Access:
Meas Setup, Trig Source

Frequency Commands

Center Frequency
[:SENSe]:FREQuency:CENTer <freq>
[:SENSe]:FREQuency:CENTer?
Set the center frequency.
Factory Preset
and *RST: 1 GHz for Modulation Analysis
Range The same as the SA mode range
128 Chapter 7