Instrument Subsystem; Select Application By Number - Agilent Technologies ESA-E Series User And Programming Manual

INSTrument Subsystem

This subsystem includes commands for querying and selecting
instrument measurement (personality option) modes.

Select Application by Number

:INSTrument:NSELect <integer>
:INSTrument:NSELect?
Select the measurement application by its instrument number. The
actual available choices depends upon which applications are installed
in the instrument.
If you are using the SCPI status registers and the analyzer mode is
NOTE
changed, the status bits should be read, and any errors resolved, prior
to switching modes. Error conditions that exist prior to switching modes
cannot be detected using the condition registers after the mode change.
This is true unless they recur after the mode change, although
transitions of these conditions can be detected using the event registers.
Changing modes resets all SCPI status registers and mask registers to
their power-on defaults. Hence, any event or condition register masks
must be re-established after a mode change. Also note that the power
up status bit is set by any mode change, since that is the default state
after power up.
Factory Preset
and *RST:
Range:
Front Panel
Access:
Chapter 7
1 = SA
229 = MAN
Persistent state with factory default of 1
1 to x, where x depends upon which applications are
installed.
Mode
Programming Language Reference
INSTrument Subsystem
111