Front-Panel Key Reference
Trig
Trig
Accesses the RF Burst and external menu keys allowing you to set various
parameters. These parameters can be accessed and set using the
Trigger
Accesses the External and RF Burst menu keys allowing you to set various
parameters. For the external configuration you can set
External Slope
RF Peak Level
External
Delay
Slope
RF Burst
Delay
Peak Level
Option B7E: RF Comms Hardware has two possible part numbers. Press
NOTE
More, Show Hdwr
out the part number. If the part number is E440160087, it is important to set the RF
Burst Peak Level to an appropriate level that will avoid the AM transitions which
can occur during the active part of the burst, and which can lead to mis-triggering
of the measurement.
To set the RF Burst Peak level, press
peak level in dB.
94
data form and menus, refer to
. For the RF Burst configuration you can set
.
Allows you to set the trigger delay when using the rear panel
external trigger source.
Allows you to set the triggering to occur on a positive-going
edge or a negative-going edge of the trigger when using the rear
panel external trigger source.
Allows you to set the trigger delay when using the RF burst
trigger source.
Allows you to set the trigger level when using the RF burst
trigger source.
to show your instrument's RF Comms Hardware and to find
Trigger... on page
90.
External Delay
RF Burst Delay
,
,
Trigger
RF Burst
Peak Level
,
Mode Setup
, and
and
System,
and enter the
Chapter 6