Phase And Quadrature Commands; Monitor Spectrum Measurement - Agilent Technologies ESA-E Series User And Programming Manual

Programming Language Reference
SENSe Subsystem
Stop Frequency
[:SENSe]:FREQuency:STOP <freq>
[:SENSe]:FREQuency:STOP?
Set the start frequency.
Factory Preset
and *RST: 1.0015 GHz
Range: The same as the SA mode range
Default Unit: Hz
Remarks: Only valid when performing a Monitor Spectrum
measurement. The option is grayed out at all other
times
Front Panel
Access:
FREQUENCY/Channel

Phase and Quadrature Commands

In-phase and Quadrature Control
[:SENSe]:IQInvert[:STATe] ON|OFF|1|0
[:SENSe]:IQInvert[:STATe]?
Allows you to swap the In-phase and Quadrature signals.
Factory Preset
and *RST: Off
Front Panel
Access:
Det/Demod, More

Monitor Spectrum Measurement

Commands for querying the monitor spectrum measurement results
and for setting to the default values are found in the
of Commands" on page
parameters described in the following commands, are found under the
key, after the
Meas Setup
selected from the
MEASURE
130
113. The equivalent front panel keys for the
measurement has been
Monitor Spectrum
key menu.
"MEASure Group
Chapter 7