Set Up
2.2.9. AS3005 AC Brushless Linear Drive Configuration
To configure a slot in the DR300 for an AC brushless linear drive module (Figure 2-12),
proceed with the following steps:
Test Point information and Electrical Specifications are provided below (Table 2-18 and
Table 2-19).
WARNING
To prevent another drive type from being inadvertently inserted into slots A and E, the
mating drive connector on the motherboard should have a key (Aerotech part number
EAM857 otherwise Schroff #21101-252) inserted into both the A and E slot. Refer to
Figure 2-3.
2-26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DR300 Operation and Technical Manual
•
Set jumpers and Drive key according to AS3005 Brushless Drive
Configuration (Table 2-6).
To minimize the risk of electrical shock and bodily injury, ensure that all electrical
power switches are in the off position and disconnect main power.
If the drive is not an AS3005 AC brushless drive, refer to the previous section.
Configure the appropriate bus power supply for bipolar operation following the
guidelines in Section 2.2.3.
Figure 2-12.
AS3005 AC Brushless Linear Drive Configuration
Aerotech, Inc.
Version 1.5