Table of Contents
Advertisement
DR300 Operation and Technical Manual
CHAPTER 3: TECHNICAL DETAILS
In This Section:
• OP500 Interconnect Cable Specifications and Connector Pinouts ................ 3-1
• DR300 Rear Panel Connectors .................................................................... 3-10
• DR300 Outline Drawings and Mechanical Specifications........................... 3-17
• Electrical Specifications .............................................................................. 3-18
• Environmental Specifications ...................................................................... 3-19
• Emergency Stop Sense Input ....................................................................... 3-20
3.1.
OP500 Interconnect Cable Specifications and Connector
Pinouts
Table 3-1 defines the pinouts for the 100-pin connector that mates with J1 on the rear of
the DR300. This is an AMPLIMITE .050" series connector that is part of the 100
conductor shielded OP500 cable that connects the DR300 to connector P1 of the
U500/U600 CPU board. The OP500 cable carries differential encoder signals as well as
analog signals, which limits the maximum cable length to 15 feet.
All input and output designations are relative to the U500/U600 CPU board,
connector P1. All connectors are N.C. (no connection) where blank.
Refer to Figure 3-1 for the location of the connectors on the rear of the DR300
Chassis assembly.
AXIS 4
AXIS 3
Note:
The connectors for Motor Power are made with (Amp 206044-1, 206070-1, and Pins 66098-7)
SERIAL TAG
Figure 3-1.
Version 1.5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
AXIS 2
AXIS 1
REAR VIEW
DR300 Rear Panel Connector Layout
Aerotech, Inc.
Technical Details
www.aerotech.com
AEROTECH
USA: (412) 963-7470
World Headquarters:
UK: (44-118) 9409400
101 Zeta Drive
Deutschland: (49-911) 967937-0
Pittsburgh, PA 15238 USA
3-1
Advertisement
Table of Contents
Troubleshooting
