Personality Module; Table 2-8. Ds160 Series Potentiometer Descriptions - Aerotech DR300 Operation & Technical Manual

DR300 Operation and Technical Manual
2.2.6.3.

Personality Module

The Personality Module pre-amplifier circuit, RCN4, (shown in Figure 2-6) is used to
interface input and tach feedback signals (if any exist). Figure 2-3 shows the location of
this module.
The user may reconfigure this module. An outline of the module is shown in Figure 2-8.
Table 2-8. DS160 Series Potentiometer Descriptions
Potentiometer
Input Provides the means of adjusting the DC gain of the input command
present at J1-Pin 16. Turning this pot CW increases gain.
Tach Provides the means of adjusting the DC gain of the tach feedback
signal present at J1-Pin 18. Turning this pot CW increases gain.
Balance Provides the means of canceling small DC offsets that may be present
in the pre-amplifier circuit.
Current Limit Provides a means of adjusting the clamp levels of the current
command signal produced by the output of the pre-amplifier. Turning
this pot CCW increases the clamp levels (increases the peak current).
Gain Provides the means of adjusting the AC Gain of the pre-amplifier.
Turning this pot CCW increases gain.
Pots are only used in Velocity Mode.
Version 1.5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Aerotech, Inc.
Set Up
2-13