Chapter 2: Set Up; Dr300 Jumper Selections And Configurations; Ac Input Voltage Configuration; Rear Panel Interface Board Internal Jumpers - Aerotech DR300 Operation & Technical Manual

Set Up
2.2.
The DR300 is already configured by the factory according to the specifications given by
the user. There should be no need to reconfigure the DR300 Chassis. However, if the
user needs to add or change the type of Amplifier for an axis, it will be necessary to
configure the slot jumpers. These jumpers are shown in Figure 2-1 and Figure 2-2 and
are described in the following sections. The "BW" type slot jumpers on the Drive
Interface board are high current jumpers and are permanently soldered to the board. The
"JP" type jumpers are two pin headers that insert and pull out of a socket.

2.2.1. AC Input Voltage Configuration

See Chapter 4: Soft-Start / Voltage Selector Board (section 4.3.).

2.2.2. Rear Panel Interface Board Internal Jumpers

This section covers the configurations of the slot jumpers on the DR300 Rear Panel
Interface board. Table 2-1 lists the configurations and jumper selections for the Rear
Panel Interface Board.
2-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DR300 Operation and Technical Manual

DR300 Jumper Selections and Configurations

There are two circuit boards with the DR300, be sure to reference the correct jumper
table for jumper settings for each board.
Aerotech, Inc.
Version 1.5