Table 8-1, Bmk Default Settings On Me-Arc - Magnum Energy ME-ARC Series Owner's Manual

Advanced remote control

Hide thumbs Also See for ME-ARC Series:

Owner's manual (142 pages)

Table Of Contents

100

101

102

103

104

105

106

107

Table of Contents

When using the charge efﬁ ciency's Auto setting, the AH I/O value is recal-

culated after the battery has been fully charged (reaching 100% SOC) and

≥0.5% of the battery capacity has been discharged. If the sense module is

disconnected from power, the displayed AH I/O value resets to zero.

Info: The AH I/O display correlates with the 05B AmpHour Size

setting (under SETUP button) to help determine the 04B SOC dis-

play. AH I/O example—if you run a 10-amp load for three hours,

the display will show -30 AH. When you begin charging, the display

will count from -30 AH back toward 0 AH.

•

04F Reset AH Out – This meter displays the total amp-hours removed

from the battery since it was last reset. This display can be used as a bat-

tery load indicator to help identify and monitor the battery load consump-

tion. The range is 0 to 65,535.0 amp-hours (0.1 amp-hour resolution).

To reset the amp-hours value to zero, press and hold the rotary SELECT knob for

>5 seconds when the Reset AH Out display is shown. After this display has been

reset, it will begin calculating and displaying new rAH out values. This display

automatically resets to zero if the sense module is disconnected from power.

•

04G Total AH Out – This meter displays the total amp-hours removed

from the battery since the sense module was ﬁ rst connected. This display

can be used as a battery service life indicator. The value is displayed in

0.1k [or 100 amp-hours ("k" equals 1000)] resolution up to a maximum

of 6,553.5k AHs (6,553,500 amp-hours). The displayed number resets to

0.0k when the sense module is disconnected from power.

•

04H Minimum VDC – This menu displays the lowest battery voltage since

the last reset. The voltage shown on the display is averaged each sec-

ond, and is helpful when troubleshooting or detecting an over-discharge

condition. To reset this display, press and hold the rotary SELECT knob

for ﬁ ve seconds while the Minimum VDC display is shown. After this

value has been reset, the display will begin monitoring and showing new

minimum DC input values. If the battery monitor is not connected or not

communicating, the display will show "0.0".

•

04I Maximum VDC – This menu displays the highest battery voltage

since the last reset. The voltage shown on the display is averaged each

second, and this allows you to check your charging system (battery

charger, charge controller, etc.) to ensure the charging voltage has been

attained. This display is also helpful when troubleshooting or detecting

if an over-charge condition has occurred. To reset this display, press

and hold the rotary SELECT knob for ﬁ ve seconds while the Maximum

VDC display is shown. After this value has been reset, the display be-

gins monitoring and showing new maximum DC input values. If the

battery monitor is not connected or not communicating, the display

shows "0.0".