Table 3-3, Inverter/Charger Default Settings On Me-Arc - Magnum Energy ME-ARC Series Owner's Manual

Advanced remote control

Hide thumbs Also See for ME-ARC Series:

Owner's manual (107 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

122

123

124

125

126

127

128

129

130

131

132

133

134

135

136

137

138

139

140

141

142

Table of Contents

Resetting/Clearing a PIN

You can override a previously entered PIN. When "PIN = 0***" displays, press and hold the SE-

LECT knob until "PIN = 0000" displays (approximately 7 seconds). Enter a new PIN number.

TECH: 06 Ext Control

External Control is a read only menu. Magnum Energy has adopted an open protocol policy which

allows certain functions of the inverter/charger to be controlled externally—such as with a third

party communications device. "Yes" displays if any external device/software is controlling the

remote. This menu is designed to help Magnum Energy technical support personnel determine if

the inverter/charger is operating normally, or being controlled by a third party.

•

No Ext Control – Indicates no third party network device is controlling any inverter/charger

functions or the ME-ARC remote.

•

Yes – When this display shows a number or a series of numbers (i.e., 04 05 10 20 ## ##

## ##), it indicates that one or more of the allowable functions of the inverter/charger is

currently being controlled externally. The number(s) displayed can be used by Magnum tech-

nicians to determine what function(s) in the inverter/charger is being controlled.

TECH: 07 Show all Menus

This menu enables you to have the ME-ARC remote display all available screens (YES), or to just

display those screens that pertain to the devices and accessories currently active (NO).

TECH: 08 Load Defaults

This menu restores factory defaults to all settings on the inverter/charger and to any defaults

on any accessories that are networked. To restore all defaults, depress the SELECT knob for 5

seconds (once countdown is ﬁ nished the screen displays "DEFAULTS LOADED"). Refer to Table

3-3 for the remote's inverter/charger default values (see also Table 7-6 and Table 10-1 for the

remote's AGS and PT default values, respectively).

Info: For information on the factory default settings for any networked accessory, refer

to the owner's manual for that accessory.

Info: If a PIN has been set and locked, it must be entered before the Load Defaults

menu can be used.