2.0 Installation
2.0 Installation
Review this section and the Important Product Safety Instructions on the
front inside cover before proceeding with the installation of your remote.
WARNING: Installations should be performed by qualifi ed per-
sonnel, such as a licensed or certifi ed electrician. The installer
determines which safety codes apply and ensures all applicable
installation requirements are followed. Applicable installation codes
vary depending on the specifi c location and application.
CAUTION: When connecting battery power to the inverter, all
battery negative connections must be connected prior to the bat-
tery positive connections. When removing battery power from the
inverter, the battery positive should be removed before any battery
negative connections are disconnected. This prevents any communi-
cation chips/lines from becoming the DC return path to the battery—
causing permanent damage to all connected accessories.
Summation: Ensure all battery negative circuits are always con-
nected before connecting or disconnecting battery positive.
2.1 Pre-Installation
Before proceeding, read the entire Installation section to determine how
best to install your ME-ARC remote. The more thorough you plan in the
beginning, the better your inverter needs will be met.
2.1.1 Installation Guidelines
•
Before connecting any wires determine the remote's cable route through-
out the home or vehicle/boat, both to and from the inverter.
•
Always check for existing electrical, plumbing, or other areas of potential
damage BEFORE drilling or cutting into walls to mount the remote.
•
Make sure all wires have a smooth bend radius and do not become kinked.
•
If installing this remote in a boat, RV, or truck ensure the conductors
passing through walls, bulkheads, or other structural members are pro-
tected. This minimizes insulation damage (such as chafi ng) which can
be caused by vibration or constant rubbing.
2.1.2 Unpacking and Inspection
Carefully remove the ME-ARC remote from its shipping container and inspect
all contents. Verify the following items are included:
•
The ME-ARC remote display
•
Bezel
•
50' remote cable
•
Eight #8 x 3/4 Phillips screws
•
ME-ARC owner's manual
If items appear to be missing or damaged, contact your authorized Magnum
Energy dealer or Magnum Energy. Save your proof-of-purchase as a record
of your ownership; it is needed if the unit should require in-warranty service.
2.1.3 Tools Required
Installing the remote control is simple and requires the following tools:
•
Phillips screwdriver
•
Cut-out tool (knife/saw)
2
• Level
• Drill
• Pencil
• Drill bit (7/64")
© 2012 Magnum Energy, Inc.