Using A Me-Ags-N Module; Me-Ags-N Setup; Table 7-1, Me-Arc Autostart/Autostop Matrix - Magnum Energy ME-ARC Series Owner's Manual

7.0 Using a ME-AGS-N Module

The AGS menus under the CTRL, METER, SETUP, and TECH buttons on the
ME-ARC remote allow you to customize and monitor operating parameters,
and to help troubleshoot your autostart/autostop generator system. Use the
mini-index below to direct you to the appropriate section.
7.1 AGS Setup
7.2 AGS Functional Tests
7.3 AGS Operation/Monitoring

7.1 ME-AGS-N Setup

Press the SETUP button on the ME-ARC remote, and then rotate the SELECT
knob to the 04 AGS Setup display. The menus available from this screen al-
low the generator to be automatically started and stopped based on many
different conditions. From Table 7-1, determine the specifi c autostart and
autostop conditions with which you want the generator to be automatically
controlled, and then use that specifi c menu setting to confi gure the AGS.
Info: For information on using the CTRL, METER, and TECH but-
ton menus, refer to Section 7.3 "ME-AGS-N Operation/Monitoring".

Table 7-1, ME-ARC Autostart/Autostop Matrix

Autostart Condition
Starts on low battery
voltage (DC voltage
connected to Termi-
nals #3 and #4)
Starts at a set time
daily
Starts on high AC
amps to an inverter
load¹
Starts when the bat-
tery SOC² is low
Starts when tempera-
ture increases
Note¹: Only applicable to MS-PAE, MS-PE and MSH inverters.
Note²: Autostart/stop conditions using SOC require the ME-BMK.
© 2012 Magnum Energy, Inc.
7.0 Using an AGS Module
p. 65 7.4 Enabling the AGS
p. 76 7.5 Start/Stop Gen
p. 77 7.6 AGS Menu Maps
Autostop Condition
Stops on higher battery
voltage
Stops at Float charge
after a set time period
(using Absorb Done Time
setting)
Stops at Float charge
after battery current
requirement is low (using
Absorb Done Amps)
Stops at Float charge us-
ing a battery SOC setting
(using Absorb Done SOC
setting)²
Stops at a different set
time daily
Stops on lower AC amps
to an inverter load¹
Stops when the battery
SOC² is higher
Stops after a set time
period
p. 81
p. 81
p. 83
SETUP Menu Page
04A Gen Run 66
VDC
04A Gen Run 66
VDC (Set Stop
Gen Volts =
Float)
04A Gen Run 66
VDC (Set Stop
Gen Volts =
Float)
04A Gen Run 66
VDC (Set Stop
Gen Volts =
Float)
04B Gen Run 68
Time
04C Gen Run 68
Amps
04D Gen Run 69
SOC
04E Gen Run 70
Temp
65