Table 3-5, Me-Rc's Inverter/Charger Default Settings; Figure 3-19, Tech: 04 Load Defaults Selection - Magnum Energy ME-RC Owner's Manual

3.0 Setup
• TECH: 04 Load Defaults – This menu restores all settings on the
inverter/charger, and any settings on accessories that are networked
and controlled by the inverter (i.e., ME-AGS-N) to the factory default
settings. To restore, press and hold the rotary SELECT knob for 5
seconds. Once restored, the display will show DEFAULTS LOADED. The
inverter/charger's factory defaults are listed in Table 3-5.
Note: If a password (PIN) has been previously set, this menu will be
unavailable (i.e., locked). Refer to the TECH: 06 SETUP PIN section on
the next page for information on how to unlock this menu.
Info: For information on the factory default settings for any net-
worked accessory, refer to the owner's manual for that accessory.
TECH
Rotate to
Press
Status...
04 Load Defaults

Figure 3-19, TECH: 04 Load Defaults Selection

Table 3-5, ME-RC's Inverter/Charger Default Settings

Menu Items
SHORE Pushbutton
01 Search Watts
02 LowBattCutOut
03 Absorb Time
04 Battery Type
05 Charge Rate
06 VAC Dropout
07 Power Save
08 Screen Setup
09 Final Charge
10 Power Up Always
* - If using with a MSH4024RE model inverter (which has two AC inputs),
both AC inputs will have the same setting (i.e., in example above, both
the AC1 and AC2 inputs would have a Shore Max setting of 30A and a VAC
Dropout setting of 80 VAC).
31
Factory defaults
are loaded and
display shows:
Status...
Press and hold
DEFAULTS LOADED
for 5 seconds
Default Settings
Shore Max = 30A*
Search = 5W
LBCO = 10.0 VDC (12-volt models),
20.0 VDC (24-volt models), or
40.0 VDC (48-volt models)
Absorb Hrs = 1.5
BatType = Flooded
Max Charge = 80%
Dropout = 80 VAC*
(150 VAC for export models)
PwrSave = 15min
Contrast =100%
Brightness =50%
Final = Multi
Pwr Up = NO
©2013 Magnum Energy, Inc.