Troubleshooting; Table 6-1, Remote Control Troubleshooting Guide - Magnum Energy ME-ARC Series Owner's Manual

6.0 Troubleshooting

6.0 Troubleshooting
The remote may not be functioning correctly, use the following table to
help fi nd a solutions.

Table 6-1, Remote Control Troubleshooting Guide

Symptom Possible Cause
Display shows Static electricity
unrecognizable may have been
letters or discharged into the
symbols LCD display.
LCD text RJ11 connections on
display is communication cable
locked-up, are not making a
pushing any good connection.
button has
no response
- may show
"revision" or
"connecting"
Remote not getting
suffi cient power from
inverter.
LEDs and Remote may be
backlight are in the Power Save
off mode.
Remote is Communication
non-functional cable bad or not
(no lights, no correctly connected
text on LCD to remote port on
display, and no inverter.
response when
pressing any
button)
Inverter is not
connected to
batteries.
62
Solution
Refresh Display: press and
hold the SELECT knob for 10
seconds.
Reset remote: 1) Disconnect
remote cable from inverter for
5 seconds and reconnect; 2)
Check RJ11 cable connection on
back of remote (see Figure 2-2).
Important: Ensure the RJ11
connector is pushed into
the correct port. You should
feel/hear a "click" when the
connection is made.
Ensure inverter batteries are
connected and inverter is
operating correctly; inverter
should be able to invert and
power AC loads from batteries
(ensure no AC power is
connected to the inverter AC
inputs).
Press any button to reactivate
the remote (or turn Power Save
mode Off).
Check communications cable
from inverter to remote;
ensure: 1) it is connected to
the REMOTE port, 2) the correct
communications cable is used
(a 4-conductor telephone
cable may be substituted to
determine if cable is good).
Ensure inverter batteries are
connected and the inverter
is operating correctly without
any AC power connected (can
invert and power AC loads from
batteries).
© 2012 Magnum Energy, Inc.